Apple Multiple Scan 14 Display - Manual (Page 11)

Choosing a good location for your monitor
Here are some key factors to consider when determining where to place your
monitor:
m Be sure that the desk or table can support the monitor’s weight—
approximately 25 pounds (11 kilograms).
m Make sure that the power cord will reach an available three-hole grounded
AC outlet.
m Make sure the monitor cable will reach from the back of the monitor to
your computer. The monitor cable should be unobstructed when you swivel
and tilt the monitor, so allow at least 6 inches (15 cm) of clearance in the
back. If you don’t allow enough clearance, the monitor connector might be
damaged when the cable hits an obstruction.
Installing the monitor base
After choosing a good location for the monitor, install the monitor base. The
monitor is intended to be operated with the base attached. It’s recommended
that you install the base before plugging in the display.
1 Place the monitor on its side to expose the mounting, where the base will be attached.
2 Holding the base so that the latch is toward the back of the monitor, insert the base into
the mounting.
As you insert the base, fit the hooked tabs into the slots in the mounting.
Mounting
Release latch
5 Setting Up