Apple Xserve Intel (Late 2006) DIY Procedure for Power Distribution Board - Manual (Page 3)

Xserve (Late 2006) Power Distribution Board Replacement Instructions
Removing the Installed Power Distribution Board
Note: Before removing the power distribution board, you must remove the following:
All Apple drive modules
Both power supplies
Power distribution board cable
Airflow duct
Fan array
Drive interconnect backplane
Apple Drive Modules
Press the handle on the front of the drive module so that the handle pops out. Then grasp
the drive handle, and pull the drive module out of the Xserve.
Repeat for all other installed drive modules.
Power Supplies
Pull the handle to release the first power supply and slide it out of the bay.
Repeat for the second power supply, if installed.
Pull the handle to unlatch the
power supply and remove it.
•
•
•
•
•
•
1.
2.
1.
2.