Apple Xserve (Early 2008) DIY Procedure for Logic Board - Manual (Page 20)

Xserve (Late 2006/Early 2008) Logic Board Replacement Instructions 20
Installing the Replacement Logic Board
Important: When replacing the logic board, make sure the board’s rear port connectors fit
through the appropriate openings in the Xserve’s back panel. Take special care to fit the clear
plastic system identifier button through its opening. Don’t bend or flex the logic board.
With the front edge of the board raised 1–2 inches (3–5 cm), guide the connectors on the 1.
back edge of the board into the openings in the back panel of the enclosure, and then lower
the front edge of the board into place.
Remove the battery insulator tab from the battery holder on the replacement logic board. 2.
Note: Depending on the Xserve model, the battery position may differ from what is shown.