Apple Xserve Intel (Late 2006) DIY Procedure for Fan Array w/Foam - Manual (Page 5)

Xserve (Late 2006) Fan Array Replacement Instructions 5
Installing the Replacement Fan Array
Install the foam included in the replacement parts box on the replacement fan array, as
illustrated below.
Align the power connector on the fan array with its connector on the power distribution
board and lower the array into the enclosure. Push down on the fan array power connector
to make sure it is fully seated.
Tighten the screws at the ends of the array. Make sure the large front panel board cable runs
above the power connector but below the tab on the top of the power supply.
1.
2.
3.