Apple Xserve Intel (Late 2006) DIY Procedure for Heatsink - Manual (Page 2)

Xserve (Late 2006) Processor Heat Sink Replacement Instructions
Warning: Always shut down the Xserve before opening it to avoid damaging its internal
components or the components you want to install or remove. Don’t open the Xserve
or try to install or remove items inside while it is turned on. Even after you shut down
the Xserve, its internal components can be very hot. Let it cool down for 5 to 10 minutes
before you open it.
Unplug all cables from the Xserve.
Note: If you have trouble releasing a cable from the back panel, try using a small screwdriver
or other flat tool to depress the tab on the cable connector.
To avoid inadvertently unlatching a drive module during handling, use the enclosure key to
lock the enclosure lock on the front panel.
Touch the server’s metal case to discharge any static electricity.
Loosen the thumbscrews at both ends of the front panel.
Grasp the thumbscrews and pull the Xserve forward until the safety latches engage (about
halfway out of the rack).
Latches
Thumbscrews
When the safety latches engage, grip the Xserve where it emerges from the rack, press down
on the latch tabs with your thumbs, and slide the Xserve the rest of the way out of the rack.
Set the Xserve on a flat surface and unlock it.
3.
4.
5.
6.
7.
8.
9.