Apple Xserve Intel (Late 2006) DIY Procedure for Logic Board - Manual (Page 12)

Xserve (Late 2006) Logic Board Replacement Instructions 1
Video Mezzanine Card (if installed)
Remove the four Phillips screws that fasten the mezzanine card to the logic board.
Pull up evenly on all sides of the card to disconnect it from its logic board connector under
the card, and remove the card from the Xserve.
Logic Board
Caution: Be careful not to flex the logic board or handle it by its components or heat sinks, which
could damage the board or its components. To minimize flexing, always grasp the logic board
only by its thumbscrews or edges when removing or installing it.
1.
2.