Apple Xserve Intel (Late 2006) DIY Procedure for Thermal Grease Kit - Manual (Page 8)

Xserve (Late 2006) Thermal Grease Kit Instructions
Rotate the top of the holder to the closed position.
Engage the latch on the processor holder.
Repeat steps 1–9 for the second processor.
Installing the Processor Heat Sinks
Important: Before re-installing each heat sink, be sure to clean off any existing thermal grease
from the underside of the heat sink.
Holding the heat sink in one hand, reconnect the 2-pin thermal sensor cable for the left
processor (CPU B) heat sink to the logic board.
Note: Make sure the connector on the sensor cable is oriented as illustrated, with the gold
fingers facing up.
8.
9.
10.
1.