Apple Xserve Intel (Late 2006) DIY Procedure for Optical Drive Cable - Manual (Page 2)

Xserve/Xserve G5 Optical Drive - 2
4. If the server is in the locked position (the yellow security LED on the front panel is on),
use the Allen key that came with the server to unlock it.
5. If the cable management arm is not in use, unplug all external cables except the
power cord.
6. Touch the server’s metal case to discharge any static electricity.
Important: Always ground yourself by touching the server’s case before you touch
any parts or install any components inside the server. To avoid static electricity
building back up in your body, do not walk around the room until you have completed
your work and closed the computer.
7. Unplug the power cord.
Warning: The power supply in the server is a high-voltage component and should
not be opened for any reason, even when the server is off.
8. Release the two thumb screws at the front of the server. (Figure 1)
Note: The thumbscrews are captive and do not separate from the bottom housing.
Figure 1