Apple Xserve (Early 2008) DIY Procedure for Light Pipe Assembly - Manual (Page 3)

Xserve (Early 2008) Light Pipe Assembly Replacement Instructions 3
Removing the Installed Light Pipe Assembly
From behind the front bezel, locate the four screws and two brackets. Remove the four 1.
identical 4-mm long screws and the two brackets.
Remove the 8-mm long center screw (with star washer) that attaches the top of the bezel to 2.
the server.
Gently pull the front bezel forward, and remove it from the server. 3.
Important: When removing or replacing the bezel, be careful not to put pressure on the top
of the bezel over the optical drive slot.