J.P. Instruments EDM 730 Instrument Installation Manual - Manual (Page 18)

FAA APPROVED INSTALLATION MANUAL FOR THE EGT-701 Report 103
INSTALLING THE EGT-701 SCANNER® 1/20/09
Rev-E Page 18 of 30
27) Weight and Balance Data
TSO C43b, Temperature Indicator EGT-701
30 oz. / 1.9 lbs
EGT probe MM-111 2.0 oz. Each / 0.125 lbs
CHT probe 5050 1.5 oz. each / 0.094 lbs
Wire P.N. WK.-24 Harness 8 ft. 14.0 oz. each / 0.88 lbs
RPM, MAP, and Oil pressure 1.5 oz each / .094 lbs
40
CHANGING THE PROGRAMMED LIMITS
Setting the K-factor (Fuel Flow Option)
You must set the K factor before using the EGT-701 with fuel flow. Note the K-factor that was engraved on the fuel flow
transducer.
1. Turn on the EGT-701 and after self-test, press STEP until the instrument is cycling normally.
2. Place the select toggle switch in the FF position.
3. Start the Pilot Programming Procedure by simultaneously holding the STEP and LF buttons for five seconds. You
will see the word PROGRAM for two seconds.
4. Tap the STEP button repeatedly until you see KF-SET.
5.
Hold STEP and LF for five seconds. First digit blinks: 29.00
6. Tap or Hold LF to change flashing digit (for example): I9.00
7. Tap STEP for next digit: I9.00
8. Tap or Hold LF to change flashing digit: I8.00
9. Tap STEP for next digit: I8.00
10. Repeat steps 7 and 8 for the remaining two digits.
11. Verify the K-factor that was engraved on the fuel flow transducer is now displayed.
12. Hold STEP and LF for five seconds to exit.
13. Tap STEP
Setting the Data Recording Option Parameters
(Data Recording Option only)
If you haven’t already done so, start the pilot programming procedure; simultaneously hold the STEP and LF buttons
for five seconds. You will see the word PROGRAM for two seconds. To change the date, time and user id for the Data
Recording Option, tap the STEP button until the display shows DUMP? N. Next, simultaneously hold the STEP and
LF buttons for five seconds. Then set the date and time as show below
Tap STEP to
next item
LF sequences
through these values
Comments
MNTH I
 I2 Month
DAY
I
 3I
Day
YEAR
80
 79
1980 through 2079
HOUR
OO
 23 24 hour time. We suggest you set Zulu time.
MIN
OO
 59
Tapping the step will also zero the seconds (not shown)
USER ID N I2345 Hold both STEP and LF buttons simultaneously until the first character flashes.
Use LF to select the first character. STEP moves to the next character.
Hold both STEP and LF to exit.