Hornady RAPid Safe - Manual (Page 7)

Manual Lock
Side-Locking Tab
Status Light
7
Manual Lock
The mechanical key lock is located under the keypad panel. To manually unlock the RAPiD ™
safe, carefully remove the keypad panel by pushing the locking tab toward the “H” and then
lifting up, carefully protecting the attached wires. Press the safe lid down while turning the
key to unlock the unit.
Left-Hand/Right-Hand
Feature
To reverse the keypad panel for opposite
hand usage, press the side-locking tab
and reverse the keypad panel, carefully
protecting the attached wires.
Batteries
For backup or mobile use, your safe requires
eight AA batteries (not included). To install
or replace batteries, carefully remove the
keypad panel and battery case cover. Only
use new alkaline AA batteries. Verify the
battery pack is plugged in. Replace all
batteries at the same time.
NOTE: The RAPiD
™ safe is not designed to
operate on a 9V battery.
NOTE: Solid Amber status light indicates
low battery. Batteries should be replaced
immediately.
NOTE: Replace batteries every 12 months.