PureFlow AirDog DF-165 - 6.7L Ford 2011-2012 - Manual (Page 13)

13
AirDog
®
II Ford PowerStroke 2011 6.7L
Section 5-C Fuel Lines
Fuel Suction Line for AirDog
®
II
5C-1. Measure and cut the “Suction Hose Assembly” to the desired length. Insert the push
lock swivel fitting to the open end of the hose. Use oil to lubricate the hose ID to easy
insertion. Then tightly assemble the push lock fitting to the 90° -8 JIC fitting. Finally
tightly assemble the 90° fitting to the male -8 JIC fitting previously installed in the
“Fuel In” port.
Figure 22
5C-2. Remove the original fuel suction line Quick Connect fitting from fuel tank by squeezing
the tabs on the end of the connector together. (see figure 24) Do Not mistake the return
line with the suction line. Consult your factory manual if unsure of these procedures.
Figure 24 Figure 25
Return Line Suction Line New Suction Line
In More Detail
To release the quick-connect fitting from the fuel tank suction tube, push the fitting toward the
suction tube. With the plastic tabs firmly depressed, pull the fitting assembly from the suction
tube. Hold the Quick Connect Fitting square to the suction tube. It may be difficult to
disconnect the fitting it is cocked or becomes cocked during removal.
5C-3. Attach the other end of the “Suction Hose Assembly” to the male quick connect on the
top of the fuel module where the factory suction line was once located. A “click will be
heard when the assembly is properly connected. (Figure 25)