PureFlow AirDog DF-165 - 7.3L Ford 1999-2003 - Manual (Page 15)

15
AirDog
®
II Ford PowerStroke 1999 - 2003 7.3L
Section 6 Electrical Harness
Connecting the AirDog
®
II Relay Control Lead
6-2. Route to Relay Lead to the fuse panel. Insert the mini fuse tap into a spare fuse holder
on the panel that is “hot” when the starter key is turned to the on position.
Figure 49 Figure 50
6-3 . OR Route the AirDog®II 'Relay activation lead', the Red (+) wire with the mini fuse
tap attached, to the OE fuel pump. Remove the mini fuse tap and splice the relay lead
to the OE fuel pump lead.
NOTE: The power supply leads can be connected to the battery or the alternator. Connecting
the power supply leads to the alternator instead of the battery will create a corrosion free
connection.
Black (-) Red (+)
6-4. Route the power supply leads to the alternator.
Connect the Black (-) lead to the alternator
Ground connection.
Connect the Red (+) lead to the alternator Hot
Lead going to the battery.
Figure 51
OR
6-5. Should you choose to connect the power
supply leads directly to the battery, connect
the RED (+) lead to the POSITIVE (+) post
of the driver's side battery. Connect the
BLACK (-) lead to the NEGATIVE (-) post
of the same battery.
Figure 52
6-6.
Route the wiring harness to the AirDog
®
II
and connect the 2 pin Deutsch connector
to the corresponding connector on
the AirDog
®
II.
Figure 53