PureFlow AirDog FP-150 - Dodge Cummins 1998.5-2004 - Manual (Page 21)

21
PureFlow AirDog
AirDog
®
FP-100 & FP-150 Dodge 1998.5 - 2004
Section 6 Electrical Harness, cont’d
OR
6-4B. Should you choose to connect the power
supply leads directly to the battery, connect
the RED (+) lead to the POSITIVE (+) post
of the driver's side battery. Connect the
BLACK (-) lead to the NEGATIVE (-) post
of the same battery.
Figure 51
6-5.
Route the wiring harness to the AirDog
®
and connect the 2 pin Deutsch connector
to the corresponding connector on
the AirDog
®
.
Figure 52
Section 7 Initial Startup Procedures
INITIAL START PROCEDURE
The AirDog
®
is a self priming system, however, to prevent potential damage to the system, it
is recommended to fill only the pre-filter with diesel fuel before initial startup.
7-1. Fill the pre-filter with diesel fuel.
7-2. Turn the starter key to the on/run position.
NOTE: It may be necessary to momentarily engage the starter in order for the ECM
to energize the AirDog
®
.
7-3. While the AirDog
®
is operating, bleed the fuel line to the engine of air by loosening
the fuel line connection at the engine fitting. As soon as the line is purged of air and
pure fuel is observed, properly tighten the fuel fitting.
NOTE: put a rag or shop towel
over and around fitting to prevent splatter. Catch all spilled fuel and dispose of
properly.
7-4. Start engine!
RECHECK ALL FUEL FITTINGS FOR LEAKAGE AND PROPERLY TORQUE.
BE SURE ALL FUEL LINES ARE PROPERLY ROUTED TO PROTECT FROM