PureFlow AirDog FP-150 - Dodge Cummins 1998.5-2004 - Manual (Page 12)

12
PureFlow AirDog
AirDog
®
FP-100 & FP-150 Dodge 1998.5 - 2004
Section 5-A Fuel Lines
5A-6. It is advised to remove the factory supply lines between the tank and the filter
canister. Also remove the factory supply line between the filter canister and the
injection pump. Then plug the ports on the filter canister. This will prevent fuel
spillage.
Figure 17
NOTE: Be sure to keep the ORIGINAL ENGINE RETURN LINE connected as it is from
the factory! In many cases the return runs thru the flange of the filter canister.
This section is for the 2003 – 2004 Dodge
Fuel Supply Line from the AirDog
®
to the CP3
The AirDog
®
fuel filter has a 2 micron media. When installing the AirDog
®
fuel system
it is recommended to bypass the factory filter canister.
5B-1. Remove the “banjo bolt” and the original factory fuel supply line at the fuel inlet port
of the CP-3 high pressure pump.
Figure 18
5B-2. From this point, installation of the fitting and pressure hose assembly is the same as
described in Section 5A.