PureFlow AirDog FP-150 - Dodge Cummins 1998.5-2004 - Manual (Page 18)

18
PureFlow AirDog
AirDog
®
FP-100 & FP-150 Dodge 1998.5 - 2004
Section 5-E High Flow Suction Tube
INSTALLING THE HIGH FLOW SUCTION TUBE, C ont’d
5E-5. Measure and cut the suction tube to a length that will allow approximately 1/8”
clearance off the bottom of the tank. It is suggested to form the end of the tube similar
to Figure 40.
Figure 40
5E-6. Lubricate the bulkhead fitting with motor oil. Pressing firmly, insert the suction tube
assembly into the grommet. Be sure the bulkhead fitting is completely seated in the
grommet.
Figure 41 Figure 42
5E-7. Re-install the Collection basket.
Re-install the factory return line to the proper
port of the Collection basket before the tank
is fully re-installed
Figure 43
5E-8. Connect the end of the “Suction Hose Assembly” to the bulk head fitting while it is
easily accessible. A “click” will be heard when it is properly installed.
5E-9 Any excess fuel hose can be addressed by routing the hose in a fashion to take up
the extra length, or a section of the hose can be removed. Push lock splices have
been included if you choose to remove the excess hose