PureFlow AirDog DF-100 W/O In-Tank Fuel Pump - Dodge Cummins 1998.5-2004 - Manual (Page 9)

9
AirDog
®
II- NO In-Tank Pump Dodge 1998 ½ - 2004
Section 4 AirDog ® II & Mounting Brackets
Installing the AirDog
®
II & Mounting Brackets on the Truck’s
Frame!
Figure 2 Figure 3
4-1.
Assemble the AirDog
®
mounting bracket to the frame bracket.
Figure 4 Figure 5
4-2. Use the spacer block to clear lines and wiring harnesses on the frame.
Adjust the assembly up or down on the frame bracket as necessary for clearance.
FUEL IN ENGINE
4-3. Install a 1/2” male J2004 quick connect x 3/8”
NPTF (08J2044) into the “ENGINE” and “FUEL
IN” ports in the AirDog
®
II.
Figure 6
4-4. Install the 3/8” male J2004 quick connect x 1/8” NPTF fitting (06J2044) into the
“TANK” port of the AirDog
® II. This is the smaller port next to the port marked “ENGINE”.
Figure 7
WARNING: The NPT fitting threads must be lubricated with oil or
anti-seize compound before installation to prevent galling!
4-4.
Attach the AirDog® to the frame bracket assembly.
Figure 8