Installing the airdog®ii electrical harness, Engine’s ecm, Airdog – PureFlow AirDog DF-100 W/O In-Tank Fuel Pump - Dodge Cummins 1998.5-2004 User Manual
Page 16: The airdog, Ii is controlled by the, Wiring diagram (in red), Figure 29, Figure 30, Securing the relay and fuse holder to the vehicle, Figure 31 figure 32
16
AirDog
®
II-
NO In-Tank Pump
Dodge 1998 ½ - 2004
Section 6 Electrical Harness
Installing the AirDog®II Electrical Harness
The AirDog
®
II wiring harness features water proof Deutsch connectors.
Also, water proof relay, and fuse holder. When properly installed, the
AirDog
®
II is controlled by the
engine’s ECM.
WIRING DIAGRAM (In Red)
Figure 29
The AirDog
®
II is activated by the ECM through a relay controlled wiring harness connecting
directly to the original ECM Deutsch pump connector.
Figure 30
CAUTION: If the OPTIONAL Low Pressure Indicator Light is not used, be sure to insulate
the two (2) #10 Indicator Light connectors to prevent accidental contact.
Securing the Relay and Fuse Holder to the Vehicle
6-1.
Secure the relay and fuse holder to the vehicle.
Figure 31 Figure 32
CP-3
Or
VP-44