PureFlow AirDog DF-165 - Dodge Cummins 1989-1993 - Manual (Page 20)

20
PureFlow AirDog
AirDog
®
II Dodge Cummins 1989 - 1993
Section 6 Electrical Harness
Connecting the AirDog
®
II Relay Control to the Fuse Panel
6-2. Route the red, Relay Trigger, wire with the mini fuse
tap attached to the fuse panel located under the hood
on the driver’s side. Insert the mini fuse tap into a spare
fuse holder on the panel that is “hot” when the starter
key is turned to the on position.
Figure 46
6-3.
Route the pump motor lead to the AirDog
®
II
Connect the 2 pin Deutsch connector on the end of the
wiring harness into the corresponding pump motor lead
connector on the AirDog
®
II.
Figure 47
NOTE: The power supply leads can be connected to the battery or the alternator.
Connecting the power supply leads to the alternator instead of the battery
will create a corrosion free connection.
Black (-) Red (+) Replace the Protective Cover
Figure 48 Figure 49
6-4A. Route the Red & Black power supply leads to the alternator Connect the Black (-)
lead to the alternator Chassis Ground connection. Connect the Red (+) lead to the
alternator Hot Lead going to the battery.