PureFlow AirDog DF-165 - Dodge Cummins 1989-1993 - Manual (Page 11)

11
PureFlow AirDog
AirDog
®
II Dodge Cummins 1989-1993
Section 5-A Fuel to Engine
Installing the Fuel Supply Line from the AirDog
®
II to the
VE Injector Pump!
The AirDog
®
II fuel filter is made of 2 micron media. For optimum engine performance,
it is recommended to bypass the factory filter canister when installing the AirDog
®
II
fuel system.
5A-1. Remove the original factory fuel supply line at the fuel inlet port on the VE injector
pump.
Figure 14
5A-2. Install the 12mm x ½” male SAE J2044 (WAP 102) fitting with the seal washer
supplied into the inlet port of the VE injector pump (Ref. Figure 14) vacated by the
original fuel supply line. Do not over tighten the fitting. It may break.
5A-3 Insert the female quick connect end (see figure 15)
of the “pressure hose assembly” into the male quick
connect fitting previously installed in the port marked “ENGINE”.
You will hear a “click” when it connects.
Figure 15
5A-4. Connect the other end of the “Pressure Hose Assembly” to
the inlet fitting installed in step 5A-2. It too will “click” when properly connected.
5A-5
Any excess fuel hose can be addressed by routing the house in a fashion to take up the
extra length, or a section of the hose can be removed. Push lock splices have been
included if you choose to remove the excess hose.