Fast & Fluid HA650 - Manual (Page 25)

25
Installation HA450 / HA650 V. 1.0
4.3.2 Install the computer
1. Put the computer in the machine.
2. Connect the power cables of the computer and the screen to
the 4-way socket (A).
3. Connect an USB cable between the computer and the power
board (B).
4. Connect the keyboard, the mouse and the screen to the
computer.
4.4 Turning on the machine
1. Connect the power cable to the wall socket. When the
machine is operational, you hear two ’beeps’.
2. Make sure that the emergency stop switch is released. See
§ 3.3.4.
3. Set the computer switch to ‘ON’.
4.5 First use
1. Fill the brush container. See § 3.3.2.
2. Fill the canisters correctly. See § 3.3.3.
3. Purge with use of purge command in software. See software
documentation.
4. Do step 3 again for all canisters.
Note
Usually, the computer already has the correct software and drivers installed. If not, refer to the
instructions in the installation manuals of your software provider.
A
B
Note
First the air will come out of the nozzle. When
the output is continuous, the tube is filled.