Fast & Fluid HA650 - Manual (Page 23)

Installation HA450 / HA650 V. 1.0
23
4.1.6 Remove the plastic protection from the switchplate
1. Open the side door. See § 3.3.2.
2. Remove the plastic protection from the switchplate.
4.2 Put the machine in position
4.2.1 Move the machine to the final location, with a ramp (optional)
1. Place the ramp (A).
2. Move the machine from the pallet on to the ground.
3. Move the machine to the final location.
4. Connect the power cable to the net entry. Do not connect the
power cable to the wall socket.
4.2.2 Place the machine on the final location
1. Slide the lower sidepanel down. This will hide the wheels.
A
Note
It is advised not to remove the sidepanels,
because the chance of damaging the panel is
big.