Fast & Fluid AT550 - Manual (Page 13)

p13
© Fast & Fluid Management, AT550
B - Dispensing
Step 1 - Bring can to correct position
> >
Place the can at the right
place of the can table. Hold the can table and unloc k
the index pin with the foot
pedal. Lift the can table until the
can is in reach of the can
sensor. The can should be
just below the switch plate.
Release the index pin. Gently
release the can table.
Step 2 - Dispense colorant into base material
> >
Ensure can opening is
under the dispenser
nozzlehead and at its
optimal height Choose desired formula as
shown in software manual.
The dispenser will
sub-sequently dispense the
colorants. Lower can table if applicable.