AKiTiO Taurus Super-S3 LCM - Manual (Page 7)

Taurus Super-S3 LCM System Setup
Page 5
4. Connect the SATA and power cables to your hard drives. Be careful not to damage any
components and confirm that the cables are connected firmly.
The connector labeled J1 is HDD1 and the connector labeled J2 is HDD2.
5. Slide the inner chassis back into the outer enclosure and fasten the four screws to finish the
assembly.
6. Connect the device to the computer and turn on the power.
7. Enter the setup menu and set the RAID mode. For details, see
RAID Mode Setup .
8. Use the disk management tool (PC) or disk utility (Mac) to initialize the drive, create a new
partition and format it.
9. Done! Your drive is now ready to use.
Note
This device is designed for two hard drives and does not work when only one HDD is installed.
Important
Upon initial start up of the device and when changing the RAID mode, any existing data on the
installed hard drives will be erased. Please make sure you backup all data prior to installing
the hard drives and prior to changing the RAID mode!