AKiTiO Taurus Mini Super-S3 LCM - Manual (Page 7)

Taurus Mini Super-S3 System Setup
[5]
5. Slide the HDD tray(s) back into the case and push it lightly into place.
6. Align the rear panel with the case and fasten the hand-tightening screws to finish the
assembly.
7. Connect the interface cable to your computer and turn on the computer.
8. If bus power is insufficient (e.g. for USB and eSATA), connect the power supply to the
device and then plug it into the power outlet.
9. Use the LCD display and set your preferred RAID mode.
10. For PC users, use the disk management tool or for Mac users, use the disk utility to create
a new partition and format the drives.
11. Done! Your drive is now ready to use.
Note
This device is designed for two hard drives and does not work when only one HDD is installed.
Important
Upon initial start up of the device and when changing the RAID mode, any existing data on the
installed hard drives will be erased. Please make sure you backup all data prior to installing
the hard drives and prior to changing the RAID mode!
Important
Before turning on the power, make sure the interface cable is connected and the computer is
running, otherwise the alarm goes off and the message [HDD Error or No Interface] is shown.
It is normal for this message to appear for a few seconds when the power is turned on.