AKiTiO Taurus Mini Super-S3 LCM - Manual (Page 6)

Taurus Mini Super-S3 System Setup
[4]
2 System Setup
2.1 Hard Drive Assembly
Your unit may come with pre-installed hard drives. Before opening such an enclosure, please read
the warranty from your vendor carefully, as this could void your warranty.
1. Remove the two hand-tightening screws at top rear of the device and then remove the
upper part of the rear panel.
2. Grab the HDD tray and pull it out of the case.
3. Align the hard drive with the HDD tray as illustrated below and mount it with two screws on
each side.
4. Repeat the previous two steps for the second HDD tray.