Steele Products SP-PM160B - Manual (Page 6)

•
•
!
3.Starting and Stopping
Warning
Before starting the mower, check within the blade area for any foreign
objects and remove them.
Do not operate the mower on areas other than turf surfaces.The mower
should be sitting on its wheels on a level part of lawn before starting
operation.
(1)To start and operate the mower,
lever back
(2)
(3)The mower may be restarted at any time with the same procedure.
First turn on the red on/off switch on the
main unit,then press the safety button with one hand and
toward the handle grip with another hand.
To stop the mower,just release the level ,the motor will switch off, then
turn off the on/off switch on the main unit.
pull the starting
13
2
3
3
13
4.Reset Button
The reset button on the main body of the machine is to prevent any damage
occurring to the battery or the motor due to a current overload, such as from the
blade jamming. 14
To restart the mower wait for a few seconds then press the reset button so that
it is level.
If the Reset button operates then following actions are recommended: 14
(1) Make a first cut with a high cutting height then make a second cut with a lower
cutting height.(See cutting height adjustment section on previous page)
(2) Push the Mower more slowly.
(3)Check the blade is correctly adjusted so the grass is cutting cleanly.
5.Mowing
To obtain a clean cut, push the mower in straight lines (passes) at a deliberate
walking pace. Overlap the passes to even the cut and to avoid any uncut strips.
If you hear the motor in the mower change pitch dramatically while mowing, it
may be overloaded.
Check to see if the grass is very thick or long, A first cut with height set higher
will help reduce the load on the motor.(See Cutting Height Adjustment section).
Push the mower more slowly when cutting thick grass.
6. Mowing Using the Grass Catcher (Optional Accessory)
The grass catcher collects the clippings as it mows. It attaches at the grass catcher
hooks on the mower and by the strap to the mower handle. Mow using the same
procedure as for normal mowing (above).
10
The roller apron keeps clippings from falling down between the cutting bar and the
roller thus missing the grass catcher. The roller apron is installed just behind the
cutting bar using the two screws provided.Once the roller apron is installed it is
not necessary to remove it whether or not you are using the grass catcher.
MAINTENANCE
! Caution: Remove the battery before carrying out any maintenance.
Do not accidentally turn the unit on while cleaning it.
Check for any faults such as loose or damaged blades, loose fittings, and worn or
damaged components.If necessary carry out any repairs before using the mower
again.
Check that covers and guards are correctly fitted,and are not damaged in any way.
Clean the Mower using a soft brush or cloth.Do not use abrasive material to clean
the product or immerse it in water.
Don't pick up liquids or use on wet ground.
Don't use on concrete,tar macadam or other rough surfaces.
Don't pick up pieces of string,stones or fabrics with the unit.
Be aware of raised areas such as paving stones or manhole covers that can
damage the blades.
STORAGE
Before storing,remove the battery.Turn the machine on its side and clean the
blade area.If grass cuttings are compacted in the blade area,remove with a
wooden or plastic implement.Remove all grass and debris,Clean the exterior of
the machine thoroughly using a soft brush or cloth.Do not use water,sovents or
polish.
Store the Mower in a dry place and oil the blaes.
Do not place other objects on top of the machine.
Always charge the battery after use, and every 3 months if stored for a long period
of time.
For Storage in confined spaces the handles can be removed from the Mower.
Disconnect the power cord and flex the lower handles to remove from the frame
locating lugs.
11