ARB 3438320 - Manual (Page 11)

Last Rev Date: 17/11/2009 Page 11 of 18 Fitting instructions# 3787059
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
WINCH FITMENT ONLY
IF FITTING A WINCH
39. Rotate the winch motor 90 degrees as shown,
so that the terminals are facing upwards once
winch is fitted to bull bar
NOTE: Follow the winch manufacturers
instructions regards motor rotation and
drainage requirements
40. Remove the cap head screws retaining the
gearbox to the winch drum. Carefully lift the
gearbox a small amount (5 mm ) and
rotate144 degrees counter clockwise (four
hole spacings) and re-fit the cap screws . This
places the winch handle in the correct
orientation.
41. Lay the winch on a suitable flat surface and
place the bull bar on top so that the wire rope
will feed thru from the bottom.
42. Using the two 3/8” x 1 1/2”long bolts, M10 flat
and spring washers, attach the bull bar to the
winch through the top two bolt holes as
shown.
Fit two top 1 ½” long
bolts first