ARB RD94 - Manual (Page 9)

2 Removing the Existing Differential
7
2.5 Checking the Current Backlash Amount
IMPORTANT:
This step is a precautionary measure recommended by ARB due to
the fact that some after market ring and pinion sets have been
manufactured to run with different backlash settings than those
specified by your vehicle manufacturer. Although ARB must
recommend you set backlash according to your service manual
guidelines, we also advise that you compare the backlash
measurements taken here to the recommended backlash settings in
your vehicle service manual. Measurements found to be outside of
your service manual recommendations may indicate the need to
deviate from those settings in order to achieve quiet running with a
good contact mark.
Refer to your vehicle service manual or your local authorised ARB
installer for more information.
c Set a depth indicator on one of the ring gear teeth as in figure 2.
Figure 2.
c While supporting the pinion gear by holding the drive shaft, rotate
the differential in both directions while observing the maximum
variation in depth from the indicator (i.e., the highest value minus
the lowest value). This value is referred to as the ring and pinion
backlash.
c Rotate the differential center 90
°
and measure again for accuracy.
c Record the average of all measurements.
2.6 Removing the Differential Carrier
c Remove the bearing caps from the differential housing.
c Carefully remove the differential carrier from the differential
housing.