ARB RD114 - Manual (Page 18)

3 Installing the Air Locker
16
3.8 Profiling the Seal Housing Tube
c Without using sharp, jagged tools such as pliers (your hands are
the best tool for this job), gently bend the seal housing tube so that
it runs closely beside the seal housing bracket (without contacting
it) and through the tapped bulkhead port as shown in Figure 9.
NOTE : It is a good idea to keep the tube away from the axle
housing casting as any contact due to vibration or
shock may wear the tube and eventually cause a leak.
Figure 9.