ARB RD82 - Manual (Page 24)

4 Installing the Air Locker
22
Figure 14.
NOTE : Excessive tightening of the center compression nut is
not necessary to form a good seal around the tube
and may damage the O-ring, the seal housing tube, or
the threads of the compression nut.
NOTE : Make sure the seal housing tube is all of the way into
the center compression nut while you are tightening
it.
Again check that no part of the seal housing tube comes in contact
with the moving differential components. Less than 8mm [5/16”]
should be considered too little clearance. Gently bend the tube
away from moving parts if necessary.