ARB RD168 - Manual (Page 28)

4 Installing the Air System
26
4.1 Mounting the Solenoid
4.1.1
Connection to an ARB Air Compressor (Fig.16.)
F
Remove one of the 1/8” BSP plugs from its port in the compressor
tank.
F Apply Teflon paste to the nipple (1/8” X 1/8” BSP) and insert it into
the port and tighten.
F Apply Teflon paste to the free end of the nipple.
F Assemble the inlet port side of the solenoid (stamped with a ‘1’)
onto the nipple and tighten. The solenoid should be rotated into a
position that does not obstruct any other ports on the compressor
tank.
NOTE : The solenoid exhausts compressed air through the
center of the black retaining cap when the Air Locker
is disengaged. Make sure this orifice cannot be
obstructed.
F Apply Teflon paste to the threads of the 5mm push-in fitting and
assemble it into the solenoid outlet port (stamped “2”) and tighten.
Figure 16.
ARB
Air Compressor