ARB RD93 - Manual (Page 6)

2 Removing the Existing Differential
4
1.2 Tool-Kit Recommendations
Below is a list of tools and supplies you may need to complete this
installation. Requirements for your vehicle may vary. Please consult your
vehicle service manual for additional recommendations.
1.2.1 Tools
Standard automotive sizes (metric and/or imperial) of sockets,
wrenches, Allan keys, and drills.
A dial indicator or other suitable measuring tool for checking ring &
pinion backlash.
A razor knife for nylon tubing.
A suitable adjuster nut wrench to set backlash and preload for your
model of axle assembly.
A torque wrench (See vehicle service manual for required torque
range)
A lubricant drain reservoir.
A 11.2mm [7/16”] drill and ¼”NPT tap for bulkhead fitting installation.
Needle-nosed pliers.
An automotive bearing puller (2 jawed) or a differential carrier bearing
puller.
A bearing press or arbor press.
1.2.2 Supplies
Thread lubricant/sealant compound (e.g., LOCTITE #567)
Thread locking compound (e.g., LOCTITE #272)
A gasket sealant or replacement gasket for your differential cover.
A sufficient volume of differential oil to completely refill your housing.
(see the ARB Air Locker Operating and Service Manual for
recommended lubricants)
A soap and water mixture to test for air leaks.
Teflon paste.