Fluid Management Dual-Pump Harbil - Manual (Page 7)

ITEM PART NO. DESCRIPTION NO.REO.
4419000 Cover, Manual Assembly. 192 oz. 1
1 4419005 Cap, Knob.192 oz. 1
2 4419004 Knob, Crank.192 oz. 1
3 4000063 Pin, Roll,1/8 x 3/4...SS 1
4 4419002 Crank, Manual, w/Knob.192 oz. 1
4 4419006 Crank, Manual. Only.192 oz. 1
5 4430002 Connector, Agitator. 5/16... w/Screw 1
6 4419001 Cover, Canister, Manual Only 1
7 4000028 Screw. Set.10-32 x 1/4...Slot, SS 1
8 4418007 Pin, Dowell.1/8 x 3/8...Steel 2
DUAL PUMP 192 OZ.
COVER, MANUAL ASSEMBLY
GENERAL INSTRUCTIONS
4. MEASURING AND DISPENSING THE COLORANT
The Dual Pump Color Dispenser has a one ounce and a five ounce capacity
dispensing pump on each canister.
The one ounce capacity dispensing pump is equipped with a gauge assembly
calibrated· for the colorant system designated by the purchaser and is used
when dispensing into base paint containers of one gallon size or less.
The five ounce capacity dispensing pump is equipped with a dual calibration
gauge assembly. The right side of the gauge assembly is calibrated in the same
incrementation as the gauge assembly on the one ounce pump. The same formula
that is used to dispense from the one ounce pump into one gallon containers
can be used to dispense from the five ounce pump into five gallon containers,
without requiring formula conversion. The left side of the gauge assembly is
calibrated in true volume increments from one-eighth ounce to five ounces and
is used for dispensing large amounts of colorant.
A. MEASURING THE ONE OUNCE DISPENSING PUMP
Tum the pump gauge to the right to disengage it from the indicator
pointer. Raise the pump gauge so that the indicator is opposite the notch
on the gauge corresponding to the amount of colorant to
be dispensed.
Then turn the handle to the left and move the indicator into the desired
notch. If the colorant is heavy-bodied, allow a few seconds for the
colorant to completely fill the pump.
Open the dispensing valve by pulling the valve lever forward to the one
ounce pump dispensing position (see illustration on page 7) until a
positive stop is felt.
With the valve lever open, tum the pump gauge to the right to disengage
it from the indicator pointer and depress fully.
Return the valve lever to the closed (up) position.
20
5