Philips AZ2725-17 - Manual (Page 9)

SPEAKERS OPERATION
Attaching the speakers
• Slide the speakers down into the sleeves on the sides of the cabinet.
The speakers will click into position.
Taking off the speakers
• Keep the levers (found on the back corners of the speaker) pressed and
slide the speaker upward.
Connecting the speakers
1. Connect the right speaker to the terminal R, with the red wire to + and
the black wire to –.
2. Clip the exposed portion of the wire into the corresponding color
terminal.
3. Repeat the wiring procedure for the left speaker to terminal L, making
sure that you connect the red wire to + and the black wire to –.
Positioning the speakers
The ideal position is obtained when the 2 front speakers and the listening
position build an equilateral triangle and the speakers are at ear-height.
Note: Speakers with an impedance of 4 ohms or more may be used.
Do not use speakers with a lower impedance, as this will damage your
set.
General operation
1. To switch on the set, choose the sound source by using the source
selector 6.
2. Adjust the sound using the VOLUME 3 42, TONE 4 and DBB 1
controls.
3. To switch off the set, move the source selector 6 to TAPE/OFF
position. Make sure the cassette keys are released.
OPERATION
REMOVABLE SPEAKERS
9
AZ 2725/17 page 9
English
DYNAMIC BASS BOOST
DBB
D DI
TONE TONE
VOLUME VOLUME DYNAMIC BASS BOOST
MODE MODE
SEARC H SEARC H
REMOT E SENSO R REMOT E SENSO R
DBB
UNLOCK
SPEAKER
MAINS ~
SPEAKER R + – L – +
MAINS ~
SPEAKER R + – L – +
LEFT RIGHT
10 mm
- L + + R -
XP AZ 2725/17 29-03-2001 13:27 Pagina 9