Philips MCM240-37B - Manual (Page 14)

14
English
Basic playback controls
To play a disc
●
Press ÉÅ to start playback.
➜ The current track number and elapsed
playing time of the track are displayed during
disc playback.
To select a different track
● Press PRESET н / л (or н / л on the
remote) once or repeatedly until the desired
track number appears in the display.
● If you have selected a track number shortly after
loading a disc or in the PAUSE position, you will
need to press
ÉÅ to start playback.
Text display during playback
In CD mode
●
Press DISPLAY to show the current track
number and remaining playback time.
In MP3-CD mode
● Press DISPLAY repeatedly to show the current
album and track numbers followed by ID3
information (if available).
To find a passage within a track
1
Press and hold down on ALBUM/TUNE а /
б (or ALBUM -/+ а /б on the remote).
➜ The disc is played at high speed and low
volume.
2
When you recognize the passage you want,
release
ALBUM/TUNE а /б (or ALBUM
-/+ а /б on the remote).
➜ Normal playback continues.
To interrupt playback
● Press ÉÅduring playback.
➜ The display freezes and the elapsed playing
time flashes when playback is interrupted.
➜ To resume, press ÉÅ again.
To stop playback
●
Press
9.
Important!
The lens of the CD player should never be
touched.
Loading a disc
This CD player plays Audio Discs including CD
Recordables, CD-Rewritables and MP3 CD.
●
CD-ROM, CD-I, CDV, VCD, DVD or computer
CDs, however, are not possible.
1
Press SOURCE on the front panel of the
system to select CD or press CD on the
remote.
2
Press OPEN•CLOSE ç to open the CD
compartment.
➜ OPEN is displayed when the compartment
cover slides up.
3
Inser t a disc with the printed side facing up.
Press
OPEN•CLOSE ç again to close the
compartment.
➜ READING is displayed as the CD player
scans the contents of a disc, and then the total
number of tracks and playing time (or the total
number of albums and tracks for MP3 disc) are
shown.
CD/MP3-CD Operation
pg001-021_MCM240_37_Eng 2005.5.20, 2:23 PM 14