Philips MC503799 - Manual (Page 25)

25
English
3139 115 20751
Timer Setting
The system can switch on to CD, TUNER, or
TAPE mode automatically at a preset time,
serving as an alarm to wake you up.
IMPORTANT!
– Before setting the timer, ensure that the
clock is set correctly.
– The timer will always be switched on
after it has been set.
– The timer will not start if a recording is in
progress.
– The volume of the timer will increase
gradually from the minimum level to the
last tuned volume level.
1 Press and hold TIMER on the remote control
for more than two seconds.
➜ "AM 12:00" or "00:00" or the last timer
setting will start flashing.
➜
TIMER will start flashing.
➜ The selected source will be lighted while
other available sources are flashing.
2 Press CD 1•2•3, TUNER or TAPE to select
the desired source.
● Before setting the timer, make sure the music
source has been prepared.
CD 1•2•3
– Load the disc(s). To start from a
specific track, make a program (refer to “CD
Operation - Programming the disc tracks”).
TUNER
– tune to the desired radio station.
TAPE – load a prerecorded tape.
3 Press à or á repeatedly to set the hour for
the timer to start.
4 Press í or ë repeatedly to set the minute for
the timer to start.
5 Press TIMER to store the start time.
➜ "TIMER ON" will be displayed and followed
by the set timer "
XX:XX" and then the selected
source.
➜
TIMER will remain on the display.
● At the preset time, the selected source will play.
To exit without storing the setting
● Press Çon the system.
Notes:
– If CD is the selected source and it is not
available when the preset time is reached, Tuner
will be selected automatically.
– During timer setting, if no button is pressed
within 90 seconds, the system will exit timer setting
mode automatically.
To check the TIMER
● Press TIMER on the remote control.
➜ If the timer has been activated, the set timer
information will be displayed.
➜ If the timer has been deactivated, "OFF" will
be displayed.
To activate/deactivate the TIMER
● Press TIMER ON/OFF repeatedly on the
remote control.
➜ If activated, the last set timer information will
be shown for a few seconds and
TIMER will
appear on the display.
➜ If deactivated, “OFF” will be displayed.
To deactivate the wake up timer (five
minutes interval)
● After timer wake up, press SNOOZE on the
remote control.
➜ The system will switch to standby mode for
five minutes. After that, it resumes the timer last
selected source again.
● To cancel the snooze function, press SNOOZE
again.
Note:
– You are only able to activate the Snooze
function within 30 minutes after timer wake up.
Clock/Timer
pg 001-030/C50-C70/37-Eng 3/7/01, 3:48 PM 25