Philips DVDR985A - Manual (Page 60)

60 Using Your Recorder’s Remote Control with Your TV
CLEAR
CH
SELECT
TIMER
T/C A/CH
MUTE
VOL
3
2
2
The following buttons on your DVD Recorder’s remote control will oper-
ate the TV at any time:
• VOL +/- increases/decreases TV volume
• MUTE H
H mutes/restores the TV sound
The following buttons operate the TV if you press and hold the TV switch
on the right side of the remote while pressing these buttons:
• CH +/- Selects TV channels at the TV (not the Recorder).
• A/CH Selects the TV channel you were viewing just before switching to
the current channel.
• Number buttons 0-9 Press to choose a TV channel quickly.
• ON/OFF 2
2 Press to turn on or off the TV power.
If these buttons already operate your TV, no further action is necessary. If
they do not, follow the steps for either Automatic Remote Setup or
Manual Remote Setup to make the Recorder’s remote control operate
your TV.
There is no guarantee the remote control will work all the features on
your TV, and no guarantee the remote will operate all TV brands. This is
not a defect of the remote.
Automatic Remote Setup
1 Turn on your television and find the code for your brand of
TV in the list on page 61.
2 Point the remote control at the TV. Press and hold the
RETURN and SELECT buttons simultaneously for at least
three seconds, then release.
3 Within 30 seconds, press the Number buttons to enter the
correct three-digit code for your brand of TV.
4 See if the remote control now works your TV as described
above. If it does, you are finished. If it does not, repeat steps 1-3,
using a different code for your brand, if available.
If the remote still will not operate your TV after repeating steps 1-3
with all the codes for your brand, try the Manual Remote Setup
procedure as described below.
Automatic Remote Setup
MONITOR ON/OFF
REC/OTR NEXT PREVIOUS
REVERSE PAUSE SLOW FORWARD
STOP FSS PLAY
CLEAR
CH
SELECT
TIMER
VOL
3
2
2
Manual Remote Setup
Manual Remote Setup
1 Turn on your television.
2 Point the remote control at the TV. Press and hold the
RETURN and SELECT buttons simultaneously for at least
three seconds, then release.
3 Within 30 seconds, press and hold the ON/OFF y y button
until your TV turns off. Your TV will turn off when the remote
control finds the correct code that will allow the remote to work
your TV. When your TV turns off, immediately release the
ON/OFF y
y button. This step may take up to two minutes. If the
TV does not turn off after two minutes, release the ON/OFF y
button. The code for your TV could not be found.
4
Make sure your remote works your TV as described above.
T/C
ZOOM ANGLE SUBTITLE AUDIO
DIM REPEAT REPEAT SCAN
A/CH
TV switch