Philips 10000032 User Manual
Page 28
Flashing
Steadily lit
CONTROL PANEL MESSAGES - NOTES ON THE AQUA PRIMA CARTRIDGE FILTER
Flashing
The control panel display guides users and helps them to use the machine correctly.
Fill the coffee bean container with coffee
beans and start the coffee brewing cycle.
Fill the water tank with fresh drinking water
and load the circuits.
Load the circuit.
Empty the dregs drawer.
Important note: the dregs drawer may be emptied only when the machine
is on. The drawer must be removed for at least 5 seconds. If you empty the
drawer with the machine off, you will not be able to dispense coffee the next
time you switch the machine on.
Fit the brew group properly in place.
Fit the drip tray and dregs drawer properly
in place.
Close the front door.
Replace the water filter in the tank.
After replacing the filter in the tank, reset the
alarm by pressing the button for 5 seconds
until the light goes off.
Too high boiler temperature, load the circuit.
Let water flow out.
28
ADDITIONAL INFORMATION FOR CORRECTLY USING
THE “AQUA PRIMA” FILTER.
Please follow these simple instructions to correctly use the “Aqua prima” filter:
1. Keep the “Aqua prima” filter cool and away from sunlight; the room temperatu-
re should be between +5°C and +40°C;
2. Do not use the filter in temperatures over 60°C.
3. If the coffee machine is not used for 3 days, we recommend washing the
“Aqua prima” filter;
4 If the coffee machine is not used for more than 20 days, it is advisable to
replace the filter.
5. To store an already opened filter, seal it in a nylon bag and keep in the fridge;
do not store it in the freezer to avoid damaging the filter properties.
6. Before using the filter, leave it to soak in the water tank for 30 minutes.
7. Once it is taken out of its pack, do not keep the filter in the open air.
8. The filter must be replaced 90 days after opening the packing or after treating
60 litres of drinking water.
Flashing