Philips VRX362AT99 - Manual (Page 37)

Setting Up the VCR Plus+ Programming System (cont’d) 37
2
Now, compare the channel numbers you have written in the VCR
PLUS+ CH. and CABLE/TV CH. columns. You’ll notice that some
stations have VCR Plus+ and Cable/TV channel numbers that are
the same, and other stations have channel numbers that do not
match. Where the channel numbers DO NOT match, you must
tell the VCR the VCR Plus+ and Cable/TV channel numbers
according to the following steps.
● Make each entry within 60 seconds of the previous entry.
3
Press the VCR button, then press the MENU button.
6
Look at the lists you filled in on page 36. For stations whose
VCR Plus+ and Cable/TV channels do not match, press
the CHANNEL (Up/Down) buttons until the arrow is
beside the VCR Plus+ channel you need. Then, press the
Number buttons to enter the corresponding Cable/TV
channel from your list. (Enter a “0” before single-digit chan-
nels.) Continue this process until you have entered all the stations
on your list.
7
Press the STATUS/EXIT button to exit.
• To correct a Cable/TV channel num-
ber, repeat the steps on this page.
• To clear a Cable/TV channel number,
repeat steps 3-5 on this page. Then,
press the CHANNEL (Up/Down) but-
tons to select it. Then press the
CLEAR button. Press the
STATUS/EXIT button to exit.
• Always enter a “0” before single-
digit channels.
• To select line input for the Cable/TV
channel, press 0,0. AUX will appear
on-screen.
• When you receive the VCR from the
factory, all the VCR Plus+ channel
numbers and Cable/TV channel
numbers are the same.
Helpful Hints
TO SELECT PUSH NO. SHOWN
1 REPEAT PLAY OFF
2 ON SCREEN MODE
3 AUDIO OUT
4 LANGUAGE
5 VCR PLUS+ REF. MAP
TO END PUSH EXIT
5
Press the Number 5 button to select VCR PLUS+ REF. MAP.
VCR PLUS+ CROSS REF. MAP
VCR PLUS+ CABLE/TV
98 98
99 99
1 – – – – –> 23
2 2
TO SELECT CH PUSH CH UP/
DOWN THEN ENTER CH NO.
TO END PUSH EXIT
VCR PLUS+ CROSS REF. MAP
VCR PLUS+ CABLE/TV
98 98
99 99
1 – – – – –> 1
2 2
TO SELECT CH PUSH CH UP/
DOWN THEN ENTER CH NO.
TO END PUSH EXIT
4
Press the Number 2 button to select VCR SET UP.
3
2 Examine the lists on
page 36.
5
6
4
7
REW
PLAY
POWER
VCR PLUS+
/ENTER
SPEED
VCR
TIME SEARCH
TV
MUTE
CABLE
/DSS
VCR/TV
CHANNEL
VOLUME
REC/OTR
STATUS/EXIT
MEMORY SLOW PAUSE/STILL
MENU CLEAR EJECT
STOP
F.FWD – +
1 2 3
4 5 6
7 8 9
0 +100