Philips VRX362AT99 - Manual (Page 33)

REW
PLAY
POWER
VCR PLUS+
/ENTER
SPEED
VCR
TIME SEARCH
TV
MUTE
CABLE
/DSS
VCR/TV
CHANNEL
VOLUME
REC/OTR
STATUS/EXIT
MEMORY SLOW PAUSE/STILL
MENU CLEAR EJECT
STOP
F.FWD – +
1 2 3
4 5 6
7 8 9
0 +100
ONE TIME PROGRAM
PROGRAM 1
CHANNEL – –
TO CORRECT PUSH CLEAR
TO END PUSH EXIT
ONE TIME PROGRAM
PROGRAM 1
CHANNEL 10
TIME ON – – : – –
TO CORRECT PUSH CLEAR
TO END PUSH EXIT
6
Press two Number buttons for the hour(s) you want the
recording to begin. Press two Number buttons for the
minute(s) you want the recording to begin. Press 1 for
AM or 2 for PM. For example, for 9:30 PM, press 09, 30, 2.
ONE TIME PROGRAM
PROGRAM 1
CHANNEL 10
TIME ON 09:30 PM
TIME OFF – – : – –
TO CORRECT PUSH CLEAR
TO END PUSH EXIT
Timer Recording (cont’d) 33
4-7
4
Use the Number buttons (1 - 8) to select a slot in which
to store the timer recording. There are eight timer recording
slots. Open slots will flash on-screen.
NOTE: If you enter a number for a slot that has already been used to
store a timer recording, PREVIOUSLY SET PROGRAM will appear on-
screen for a few seconds. Then information about the program in that
slot will be displayed on-screen. If this happens, press the STATUS/EXIT
button twice. Then start again at step 1.
5
Enter the channel you want to record.
● If you have a basic antenna or cable hookup (as shown on
pages six-seven) enter the channel of the TV program you want
to record. (You must enter a 0 before all single digit channels.)
● If you are recording from line input, press 0, 0. AV REAR will
appear on-screen.
● If you are using a Cable Box, enter the Cable Box output chan-
nel (channel 03 or 04). See page eight for details.
7
Enter the recording’s stop time.
Follow the instructions in step 6 to set the recording’s stop time
(AM or PM will be set automatically).
Instructions continue on page 34.
• Entries that do not match the VCR’s
internal clock or calendar will cause
a question mark (?) to appear on-
screen.
Helpful Hint