Philips Soundbar speaker HTL5110 Virtual surround Wireless subwoofer Opt Coax Aux in Audio in Bluetooth® - Manual (Page 12)

11
English
EN
Note
• The music streaming may be interrupted by obstacles
between the device and SoundBar, such as wall, metallic
casing that covers the device, or other devices nearby
that operate in the same frequency.
• If you want to connect your SoundBar with another
Bluetooth device, press and hold Bluetooth on the
remote control to disconnect the currently connected
Bluetooth device.
• Philips does not guarantee 100% compatibility with all
Bluetooth devices.
Auto standby
When playing media from a connected device,
the SoundBar automatically switches to standby
if:
• no button is pressed for 29 minutes, and
• no audio play from a connected device.
Apply factory settings
You can reset your SoundBar to the default
settings programmed at the factory.
1
In AUX mode, within three seconds, press
VOL-, BASS-,and Treble- .
» When the factory settings restore is
complete, the SoundBar automatically
switches off and restarts.
5 Wall mount
Note
• Koninklijke Philips Electronics N.V. bears no
responsibility for improper wall mounting that results
in accident, injury or damage. If you have any query,
contact Philips Consumer Care in your country.
• Before wall mounting, make sure the wall can support
the weight of your SoundBar.
• Before wall mount, you need not remove the three
rubber feet at the bottom of the soundbar, otherwise
the rubber feet cannot be fixed back.
Screw length/diameter
Depending on the type of wall mounting your
SoundBar, make sure that you use screws of a
suitable length and diameter.
For information about how to wall mount your
SoundBar, see the quick start guide.
> 25mm
3.5-4mm
4mm
HTL5110_F7_UM_V1.0.indb 11 2013/3/15 17:00:07