Philips 42" LCD flat HDTV Pixel Plus 2 HD - Manual (Page 18)

16
Source
This menu allows you to identify the accessory devices you have connected to
the external inputs/outputs.
& Select Source in the Setup menu.
é Press the cursor right.
“ Select the input to which the accessory device is connected.
‘ Press the cursor right again to enter the list of types of devices connected
to the selected input.
( Select the accessory device with the cursor up/down.
When you select AV1 , AV2 , AV3 , HDMI1 , HDMI2 , Side or Digital Audio
In , a list appears allowing you to identify which type of accessory device is
attached to this input.The TV detects the presence of the connected device
and the signal is routed appropriately.
Once you have selected the source type, e.g. DVD, this source will
automatically be selected when your remote control is in DVD mode, see
p. 6, and when you press the
AV+ button on the remote control.
Digital Audio
Select Digital Audio In when the TV expects digital audio for a connected
device to come from a Digital audio input.
Make your selection of the source to which the device with digital audio
input has been connected.
In addition to accepting audio input via Digital Audio In, the TV can output
Digital audio via the
DIGITAL AUDIO OUT connector to an external
amplifier or receiver.
If your amplifier or receiver has a matching connector for Digital Audio In,
you can connect it with a single cable to the TV’s
DIGITAL AUDIO OUT .
See Connect Accessory Devices, Digital Surround Receiver, p. 35.