Philips VRKD11YL99 - Manual (Page 28)

28 Timer Recording (cont’d)
7
Press the PLAY button or the STOP button repeatedly
until the desired channel number appears. Then, press
the F.FWD button.
● If you are using a standard antenna/cable hookup (as shown on
page seven), select the channel of the TV program you want to
record.
● If you are recording from line input, select L1. (LineIn Rear (L1)
is located at the channel 00.) You should have the VCR con-
nected to other video equipment. Details are on page 32.
● If you are using a Cable Box/DBS, select the Cable Box/DBS
output channel (03 or 04). Select the channel you want to
record at the Cable Box/DBS. Leave the Cable Box/DBS on for
the timer recording. Details are on page eight.
ONE TIME PROGRAM
PROGRAM NUMBER 1
DATE
0 5 / 0 4 FRI
START TIME 0 7 : 3 0 P M
END TIME 0 8 : 3 0 P M
CHANNEL 16
REC SPEED – –
ONE TIME PROGRAM
PROGRAM NUMBER 1
DATE
0 5 / 0 4 FRI
START TIME 0 7 : 3 0 P M
END TIME 0 8 : 3 0 P M
CHANNEL 1 6
REC SPEED S P
B SP
SLP
8
Press the PLAY button or the STOP button repeatedly to
select a tape speed. The arrow will appear beside your choice.
The selected tape speed will flash beside REC SPEED.
9
Press the EXIT/C.RESET button.
10
Press the POWER button to turn off the VCR. The TIMER
light will appear. (The TIMER light will flash if there is not a tape in
the VCR.)
If a timer recording will take place several hours or days from
now, you may use the VCR until time for the timer recording. Just
make sure you turn off the VCR about five minutes before the
scheduled start time.
Turn off the VCR for the recording.
Insert a tape in the VCR.
Leave the Cable Box/DBS on
(if applicable).
POWER
CHANNEL
PAUSE
PLAY
STOP
F. FWD
REW
RECORD VCR/TV
SPEED MENU DISPLAY
EXIT/ C. RESET COUNTER MEMORY
10
7 8
9