Philips VRKD11YL99 - Manual (Page 19)

POWER
CHANNEL
PAUSE
PLAY
STOP
F. FWD
REW
RECORD VCR/TV
SPEED MENU DISPLAY
EXIT/ C. RESET COUNTER MEMORY
Remote Control Buttons (cont’d) 19
STOP Button
Press to stop the tape.
Use to enter information in the menu (setting the clock,
for example). Press to select an item in the menu.
PAUSE Button
During recording, press to temporarily stop the recording. Press
again to resume recording. Details are on page 24. You can not
pause a One-Touch Recording. Details are on page 25. During tape
playback, press to pause the picture. Each press of the PAUSE
button will cause the noise lines to move on the screen. Press the
PLAY button to resume normal playback. Details are on page 34.
F.FWD Button
When tape playback is stopped, press to fast forward the tape at
high speed. During tape playback, press to fast forward the tape
while the picture stays on the screen. Details are on page 34.
Press to change the setting of an item in the VCR menu or press
to go to the next menu.
Press to add or delete channel numbers. Details are on page 13.
CHANNEL o/p Button
Press to scan up or down through the available channels after the
channels have been set up. Details are on page 12.
EXIT/C(ounter).RESET Button
Press to set the real-time counter to zero. Details are on page 36.
Press to remove menus.
VCR/TV Button
Use to select the signal that your TV receives.
● VCR Position
Use to watch a tape, to watch a program while recording it, or to
watch a TV broadcast using the CHANNEL o/p button to
change channels at the VCR. The VCR/TV light will appear on
the front of the VCR when it is in VCR position.
● TV Position
Use to watch TV (changing channels at the TV) or to watch one
program while recording another. Details are on page 31.
COUNTER MEMORY Button
Press to memorize a tape position at which the real-time counter
was set to 0:00:00. Details are on page 36.