Bunn W/SMART FUNNEL S/N SNG0033000 & UP - Manual (Page 31)

Page 31
PROGRAMMING THE BREWER (cont.)
DRIP TIME (now displayed on "non" funnel lock
units as well)
This function allows the setting or modification
of the funnel locks to stay engaged after the end of
a brew cycle. This ensures that the funnel cannot be
removed until after the liquid has emptied out of the
funnel.
Procedure to modify drip times:
Range: OFF to 10 minutes for all three batch
sizes.
NOTE: If the brewer is already in the DRIP TIMES
screen, it is not necessary to follow steps 1 through
9 in this section, but proceed directly to step 10.
1. Press and hold the upper right hidden switch until
the display reads UNITS. Release the switch, then
press and hold the upper right hidden switch until
the display reads REVIEW RECIPES.
2. Press YES to proceed. The display should now
read NO NAME, along with MODIFY, SHOW and
NEXT.
3. Press and release NEXT to advance to the desired
coffee name to be modified.
4. Press and release MODIFY. The display should
read BREW OZ.
5. Press and release DONE. The display should read
3 BATCHES DONE?.
6. Press and release YES. The display should now
read % BYPASS.
7. Press and release DONE. The display should read
3 BATCHES DONE?.
8. Press and release YES. The display should now
read SET PULSE BREW.
9. Press and release NO. The display should now read
DRIP TIME, along with either the word OFF, or a
time will be showing. A batch light should also be
blinking.
10. Using the (-) and (+), set the amount of time from
when the brew solenoid shuts off to when drip-out
occurs for that batch size.
NOTE: Set to OFF to prevent funnel locks from engag-
ing (to disable this function), for a particular batch
size. To set to OFF, press and release (-) until OFF is
displayed.
P2447
REVIEW RECIPES?
NO YES
3 BATCHES DONE?
NO YES
DRIP TIME X:XX
(-) DONE (+)
NO-NAME
MODIFYSHOWNEXT
EXIT TO
NEXT FUNCTION
SCREEN
ADVANCES TO ALL OTHER
COFFEE NAMES PROGRAMMED
IN THE BREWER'S MEMORY
WHEN THE LAST COFFEE NAME
IN THE BREWER'S MEMORY IS
DISPLAYED, PRESSING NEXT
WILL EXIT AND THE DISPLAY
WILL THEN READ:
EXITS TO THE NEXT COFFEE NAME
IN THE BREWER'S MEMORY. IF NO
OTHER COFFEE NAMES ARE
ENTERED IN THE BREWER'S
MEMORY, THE DISPLAY WILL READ:
(COFFEE NAME)
MODIFYSHOWNEXT
(COFFEE NAME)
SETUP COMPLETE
THAT WAS THE
LAST RECIPE
PRESS
DONE
YES
DONE
YES
NO
NO
SCREEN DISPLAYED
BREW OZ: XX.XX
3 BATCHES DONE?
% BYPASS XX.X
3 BATCHES DONE?
SET PULSE BREW?
SET PREINFUSION?
11. When finished, press another batch size and repeat
step 10 until all three batches are set.
12. When finished, press DONE. The display should
read 3 BATCHES DONE?
13. If the three batch sizes are set correctly, press YES.
The screen should show the name of the coffee
flavor being programmed (modified) along with
SETUP COMPLETE.
14. After a 5 second delay, the display will advance to
the next coffee name in the brewer's memory. If
no other coffee names are present, the display will
read THAT WAS THE LAST RECIPE, and return to
the REVIEW RECIPES screen.
P2447
35879.1 071405