Philips 40PFL8605H-12 - Manual (Page 53)

4.5 Software
Current version
To view the current TV software version, press h > Setup >
Software settings and press OK. Select Current software info and
read Version: . . ..
Update from Internet
If the TV is connected to the Internet, you may receive a message
from Philips to update the TV software. You need a high-speed
Internet connection.
If you receive this message, we recommend you carry out the
update. Select Update. Follow the instructions on screen.
You can also look for new updates yourself. To look for an update,
press
h > Setup > Update software and press OK. Follow the
instructions on screen.
When the update is complete, the TV switches itself off and back on
again automatically. Wait for the TV to switch itself back on. Do not
use the Power switch
O on the TV.
Update with USB
It might be necessary to update the TV software. You need a PC
with an high-speed Internet connection and a USB memory device
to upload the software on the TV. Use an USB memory device with
256Mb free space. Make sure that write protection is switched off.
1 Start
2 Identify
3 Download
4 Update TV
1 Start the update on TV
To start the software update, press
h > Setup > Update now.
2 Identify the TV
Insert the USB memory on the side of the TV, select Start and press
OK. An identification file is written on the USB memory.
3 Download the TV software
Insert the USB memory in your PC. On the USB memory, locate the
file update.htm and double click it. Click on Send ID. If new software
is available, download the .zip file. After the download, unzip the file
and copy the file autorun.upg onto the USB memory. Do not place
this file in a folder.
4 Update the TV software
Insert the USB memory in the TV again. The update starts
automatically. The TV switches itself off for 10 seconds and then
back on again. Please wait.
Do not . . .
• use the remote control
• remove the USB memory from the TV
If a power cut occurs during the update, never remove the USB
memory from the TV. When the power returns, the update will
continue.
At the end of the update, the message Operation succesful appears
on screen. Remove the USB memory and press
O on the remote
control.
Do not . . .
• press
O twice
• use the O switch on the TV
The TV switches itself off (for 10 seconds) and then back on again.
Please wait.
The TV software has been updated. You can use the TV again.
To prevent an accidental update of the TV software, delete the
autorun.upg file from the USB memory.
Setup / Software 53