Philips MX3291B - Manual (Page 25)

LOCATOR POWER
AV ON/OFF POSITION FREEZE TV
VCR
ACC
SWAP SOURCE PIP CH
UP DN
SMART
SOUND
SMART
PICTURE
MENU SURF
VOL CH
MUTE
CC STATUS CLOCK A/CH
EXIT TV/VCR
SLEEP TUNER
VCR
RECORD
A/B
MULTI
MEDIA INCREDIBLE
STEREO
ANT "A"
75
L
AUDIO
R/MONO
IN-2 IN-1 OUT
VIDEO
S-VIDEO PIP ANT "B"
75
SURROUND SOUND
8 8
+ R – – L +
ATTENTION - T
1. DO NOT CONNECT SU
TO A SEPARATE AMPL
CONNECTED TO ANOT
2. DO NOT CONNECT LE
OUTPUT TOGETHER.
24
4
AV 1
AV 2
SVID-R
1
3
2
AUDIO OUT
R L S-VIDEO
OUT
ANT/CABLE
OUT
The S(uper)-Video connection on
the rear of the television can give
you better picture detail and
clarity, for the playback of S-
VHS VCR tapes, or Digital Video
Discs than the normal antenna
picture connections.
Note: The VCR (or Digital Video
Disc player) must have a S-
VIDEO OUT(put) jack in order
for you to complete the connec-
tions shown on this page.
Connect the S-VIDEO
CABLE to the S-VIDEO input
jack on the rear of the television,
then the AUDIO (red and white)
to the AUDIO IN (IN 2) jacks on
the rear of the TV.
Connect the S-VIDEO
CABLE to the S-VIDEO output
jack on the accessory device.
Then connect the red and white
AUDIO CABLES to the AUDIO
(left and right) output jacks on
the rear of the accessory device.
Turn the VCR (or Digital
Video Disc Player) ON.
Press the AV button on the
remote to tune to the SVID-R
channel. You are now ready to
view the tape or disc on the TV.
AUDIO IN
(RED/WHITE)
S
MART
H
ELP
Remember, after it is con-
nected an easy way to select
the S-VIDEO (SVID-R) mode is
to press the TV/VCR button on
the remote, or tune to the SVID-R
channel using the AV button on
the remote.
If you have added SVID-R to the
TV’s channels memory, just press
the CHANNEL + or – buttons to
select the S-VIDEO mode.
VIDEO IN
(YELLOW)
H
OW TO
U
SE THE
A
UDIO
/V
IDEO
I
NPUT
J
ACKS
BEGIN
S-VIDEO CABLE
(NOT SUPPLIED)
DSS, DVD, Video Game, etc.
(EQUIPPED WITH S-VIDEO AND
AUDIO OUTPUT JACKS)
BACK OF ACCESSORY
NOTE: Repeatedly pressing the AV
button on the remote will toggle the
picture source from the current chan-
nel, to the AV 1 connection, to the
AV 2 connection, to the SVID-R
connection.
This also applies to the Multi Media
button on the remote. Repeatedly
pressing the Multi Media button will
toggle the picture source from the
current channel to the MM 1 (AV 1)
connection, to the MM 2 (AV 2) con-
nection, to the MM 3 (SVID-R) con-
nection.
IF YOU ARE USING A
MONO DEVICE, USE
ONLY THE AUDIO
R/MONO JACK. IF A
DUMMY JACK IS
PLUGGED INTO THE
AUDIO L, NO SOUND
WILL BE HEARD.
S-V IDEO I NPUT
BACK OF TV