Philips 32PFL4909-F7 - Manual (Page 23)

Watching Channels from an External Device
Switching Each Input Mode can easily switch with the Remote Control
between TV (DTV or Analog TV) and External Devices when they are
connected to the Unit.
1
Turn On the Set-top Box or the Connected Device.
●
The picture from the Set-top Box or the Connected Device might
appear Automatically on the TV screen.
If the picture does not appear
① Press S SOURCE Repeatedly to select the Set-top Box or the
connected device and wait a few seconds till the Picture appears.
11.1
or
DTV / Analog TV
channel
e.g.)
PC
Component
Video
HDMI3
HDMI2 HDMI1
PC
Video
HDMI3
HDMI2
HDMI1
TV
● Pressing H reverses the direction of the Input modes.
② Use the Remote Control for the Set-top Box or the Connected
Device to select Channels to view.
Access the Home menu
1
Press Q (MENU).
Guide to Home menu
a
b
e
c
f
d
Setup Add new devices Net TV
Browse PC Browse USB Watch TV
a Watch TV : Switches back to the TV source if another
source is selected.
b Net TV : Accesses Net TV menus.
c Add new devices : Adds new devices to the Home menu.
d Browse USB : Accesses USB menus.
e Browse PC : Accesses DLNA menus.
f Setup : Accesses menus that allow you to change
picture, sound and other TV settings.
Note(s)
● After selecting Add new devices, follow the on-screen instructions to select the correct
device and connector.
Lock or unlock your device from the Home menu
This section describes how to lock or unlock specified device.
1
Press Q (MENU) on the remote control.
2
Use H I J K to select a device to lock or unlock.
3
Press U OPTIONS on the remote control.
4
Use H I to select Device lock or Device unlock, then press OK.
●
If device lock is unlocked, Device lock will be displayed. If device
lock is locked, Device unlock will be displayed and will be
displayed at the top right of the device icons.
5
Enter your PIN. Change PIN L p. 36
●
Once you have set PIN, PIN input menu does not appear after the
unit is Turned on.
Enable or disable RC key forwarding from the Home menu
This section describes how to enable or disable RC key forwarding for a
particular device.
1
Press Q (MENU) on the remote control.
2
Use H I J K to select a device to enable or disable RC key
forwarding.
3
Press U OPTIONS on the remote control.
4
Use H I to select Enable RC key forwarding or Disable RC key
forwarding, then press OK.
●
If RC key forwarding is set to off, Enable RC key forwarding will
be displayed. If RC key forwarding is set to on, Disable RC key
forwarding will be displayed and will be displayed at the top
left of the device icons.
Note(s)
● This function is available only when your devices are connected to this unit through HDMI
cables and assigned to an HDMI port (HDMI 1 to HDMI 3) with Add new devices in the
Home menu.
23 .
English
Continued on next page.