Philips FWC85C37 - Manual (Page 13)

3139 116 19591 (ENG)
13
Important:
Before you operate the system,
complete the preparation
procedures.
Demonstration mode
The system has a demonstration mode
that shows the various features offered
by the system. When the system is
switched on for the first time, the
demonstration mode will start
automatically.
Notes:
– During the demonstration, if you press
any source (or standby-on) button, the
system will switch to the respective
mode (or standby).
– When the system is switched to standby
or power save mode, the demonstration
will resume five seconds later.
To stop the demonstration mode
• Press and hold Ç(on the system
only) for five seconds when the
system is in demonstration mode.
™ The demonstration will stop.
™ "DEMO OFF" will be displayed.
™ The system will switch to standby
mode.
Notes:
– When the system is switched on from
the main power outlet, the CD carousel
tray may open and close again to
initialize the set.
– Even though the AC power cord is
removed from and reconnected to the
wall socket, the demonstration will
remain off until it is switched on again.
OPERATING THE SYSTEM
STANDBY ON
MINI HIFI SYSTEM
BAND C 1 • 2 • 3 CDR
STOP•CLEAR SEARCH•TUNING PLAY PAUSE PREV NEXT
DUB (HSD) RECORD A. REV DIM CLOCK/
TIMER PROG
BASS TREBLE
wOOx TECHNOLOGY
POWER SAVE
IR SENSOR
SIDE VOLUME
PLUS LEVEL
PRESET ▲ ▲ BASS/ TR EB LE
TAPE CD TUNER AUX
P E R S O N A L
D S C
VE C
TAPE 1•2 CD 1•2•3 FM•AM CDR/DVD
To start the demonstration mode
• Press and hold Ç(on the system
only) for five seconds when the
system is in standby mode.
™ The demonstration will begin.
Easy Set
EASY SET allows you to store all
available radio stations automatically.
• Press and hold STANDBY ON (on
the system only) for five seconds
when the system is in standby or
demonstration mode.
™ "EASY SET" will be displayed, and
followed by " TUNER" and then
" AUTO".
™ EASY SET will start searching for
all radio stations on FM band and
then followed by radio stations on
AM band.
™ All available radio stations with
sufficient signal strength will be
stored. Up to 40 presets may be
stored.
Notes:
– EASY SET will start with the FM band,
if there are still presets available, the
system will continue to store the AM
band.
– When EASY SET is used, all previously
stored radio stations will be replaced.
– The last preset radio station will
appear on the display when EASY SET
is completed.
Switching the system ON
• Press CD, TUNER, TAPE or AUX.
You can also switch on the system by
pressing any one of the CD DIRECT
PLAY buttons.
Switching the system to
standby mode
• Press STANDBY ON or B on
the remote control.
™ The system will switch to standby
mode.
Switching the system to
power save mode
(when
Demonstration mode is stopped)
• Press POWER SAVE to switch to
energy saving mode ( < 2 watts ).
™ "LOW POWER STANDBY ON" will
be displayed, after which the
display screen goes blank.
™ The low power STANDBY ON
LED will be lit.
Note:
– if the demonstration mode has not
been disabled, it will resume five
seconds later.
pg 01-28/C85/37-Eng 2/16/00, 9:02 AM 13